MB-300-ION-2 Nitrate Concentration Transmitter  Home: Index >> ION Transmitter

MB-300-ION-2 Nitrate Concentration Transmitter

ION-7120 Nitrate Concentration Transmitter

Application area :
The ion selective sensor is installed directly in the activated sludge tank of the sewage treatmen plant, Without any sample pretreatment or sample
transfer.The whole measuring system includes sensors and transmitters:Sensor containing electrode,Transmitter includes display and operating unit.Sensor formonitoring the concentration of Nitrate concentratio: sSludge tank sThe primary settling tank outlet

 Instructions
 Color
    Features:

    l  Without sample pretreatment, direct Nitrate concentratio measurement

    l  Chloride ion measurement is optional, can also compensate for the high concentration of interference

    l  Range:0.1-1000 mg/l NO3-N

    l Direct installation in the pool, without liquid collector or sample transfer pump

    l Compressed air cleaning optional, low maintenance cost

    l  Every 6 months to replace the coated cap, effectively extend the life of the electrode

    Parameters:


    The input measurement variables depend on the type of sensor

    Nitrate concentratio
    Chloride ion

    NO3-N,NO3- [mg/l] 0.1~1000 mg/l

    Cl- [mg/l] 1~1000 mg/l

    performance parameter:
    response timet90
    Nitrate concentratio:< 2 min. Chloride ion:< 2 min.
    Accuracy
    measured values of + 5% + 0.2 mg/l
    Repeatability
    display value of + 3%
    Correction mode  
    Two or three-point calibration, offset correction (providing three zones Section optional)
    input resistance
    >10^12Ω
    Hi/Lo Relay Output
    2 sets Hi/Lo programmable,N/OFF, 240VAC/ 0.5A Max
    Analog Output
    2 sets of programmable & isolate current DC 0/4~20mA with programable according to DO、Temp. Max. load 500Ω
    Environment condition:

    Ambient temperature range
    -20 ... 50 °C (-4 ... 120 °F)
    Storage temperature2
    2 ... 40 °C (36 ... 100 °F)
    Protection class
    IP 65
    Process condition:
    Process temperature range
    2 ... 40 °C (36 ... 100 °F)
    Maximum allowable pressure of process pressure
    400 mbar (160 inH2O)
    pH value of medium:
    Nitrate concentratio
    pH 5...8.3 (No pH compensation)w pH 5 ~10 (with pH compensation)
    Chloride ion
    pH 2 ...12